(NOTE: THE NUTS USED ON THIS BENCH ARE LOCK NUTS, THIS
MEANS YOU MUST TIGHTEN THEM DOWN PAST THE PLASTIC)
INSERT.)
ASSEMBLE THE SEAT FRAME (
B
) TO THE WEIGHT COLUMN (
A
) USING THE M12 x 70MM
BOLTS (
I
), 12 MM WASHERS (
K
) AND 12 MM LOCKNUTS (
M
). THEN INSTALL THE 2” RUBBER
BOOTS (
H
).
INSTALL TURN KNOBS (
G
) IN SEAT FRAME. DO NOT FULLY TIGHTEN YET.
NEXT INSERT THE SEAT AND ARMREST ASSEMBLY INTO THE SEAT FRAME (
B
) AND
ADJUST PULL-PINS.
ADJUSTING THE SEAT AND ARM PADS:
RAISE AND LOWER THE PADS USING THE PULL
PIN. TURN THE KNOB TO LOOSEN FOR ADJUSTMENT. MAKE SURE THE PULL PIN IS
SECURE IN THE ADJUSTMENT HOLE, THEN TURN THE KNOB TO TIGHTEN BEFORE USE.
ARMREST ASSEMBLY
SEAT ASSEMBLY
H
H
G
G
H
B
I
K
K
A
K
M
