TOOLS REQUIRED:
1) 1/2" WRENCH 2) 9/16” WRENCHES
INSTRUCTIONS:
1)
FIRST ASSEMBLE THE SEAT SLIDE USING FIGURE “B AND C USING THE
5/16-18 X 1” BOLTS (3). BEFORE INSTALLING ON THE SEAT FRAME.
2)
NOW USING FIGURE “A” SLIDE THE FRONT FOOT (7) INTO THE SEAT
FRAME (2) USING THE LOCK PIN (14). NEXT SLIDE THE SEAT ASSEMBLY (3)
ON THE SEAT FRAME (2). INSTALL THE PULL PIN (12) AND THE TIGHTEN
KNOB (13) ON THE SLIDE (3). THEN INSTALL THE PULL PIN (12) ON THE SEAT
FRAME (2).
3)
NEXT ATTACH THE MOUNTING FLANGE (6) ONTO THE WEIGHT COLUMN
(1) USING THE 3/8”-16 X 3” BOLTS (8), 3/8” WASHERS, AND 3/8-16 NUTS (9).
NOW ATTACH THE SEAT FRAME ASSEMBLY (2) TO THE WEIGHT COLUMN
(1) USING THE 3/8”-16 X 3” BOLTS (8), 3/8” WASHERS, AND 3/8-16 NUTS (9).
4)
INSTALL THE PULL PIN (12) INTO THE WEIGHT COLUMN (1) AND SLIDE
THE WEIGHT BAR HOLDERS (4) INTO THE WEIGHT COLUMN (1). NOW PUSH
THE 1” GRIPS (11) ONTO THE WEIGHT BAR HOLDERS (4)
NOTE: THE GRIPS
WILL SLIDE ON EASIER IF YOU MOISTEN THE TUBE WITH A SPONGE
BEFORE INSTALLATION.
5)
MAKE SURE ALL THE BOLTS ARE TIGHT BEFORE USE. REMEMBER TO
CHECK THEM PERIODICALLY TO MAKE SURE THEY ALWAYS STAY TIGHT.
FIGURE D
1)
ASSEMBLE THE LEG SWING (1) TO THE YOKE POST (2) USING THE 1/2”-13
X 3 1/4” BOLT (5) AND THE 1/2”-13 NUT (6).
2)
SLIDE THE PAD TUBES (4) THROUGH THE LEG SWING (1) AND THE YOKE
POST (2). NEXT SLIDE THE PADS (3) ONTO THE LEG PAD TUBES (4). THEN
SECURE THE PADS (3) USING THE MUSHROOM CAP (9).
3)
INSTALL THE 1 3/4” SQUARE CAPS (8) INTO THE LEG SWING (1) AND THE
YOKE POST (2). NOW INSTALL THE 1” RD CAP (7) INTO THE LEG SWING (1).
FINALLY INSTALL THE BUMPER (10) ON THE BACK OF THE LEG SWING (1).
FIGURE E
1)
ASSEMBLE THE PAD (E) TO THE FRAME (C) USING THE 1/4”-20 X 3/4”
BOLTS (D) AND THE FLAT WASHERS.
2)
NEXT SLIDE THE BAR HOLDER (A) ON THE ARM PAD FRAME (C) AND
SCREW IN THE PULL PIN (B).
ASSEMBLY INSTRUCTIONS FOR
THE DF141 ULTRA FIT NARROW
