9
CUTTERHEAD GUARD
1. Attach the cutterhead guard (A) Fig. 7 to the planer
by inserting the end of the guard over the top of the
cutterhead. Place the slots in the cutterhead guard (C)
over the tapped holes (B).
2. Fasten cutterhead guard (A) Fig. 8 to planer using two
knobs, one of which is shown at (D).
Make sure that the cutterhead guard is
properly secured with the knobs before operating this
machine.
FASTENING PLANER TO SUPPORTING
SURFACE
During operation, if there is any tendency for the planer to
tip over, slide or "walk" across the supporting surface, the
planer must be secured to the supporting surface. Four
holes (two of which are shown at (A) Fig. 9 are provided
for this purpose.
D
A
Fig. 8
A
B
C
Fig. 7
A
Fig. 9
OPERATION
STARTING AND STOPPING PLANER
Make sure that the switch is in the
"OFF" position before plugging cord into outlet. Do
not touch the plug’s metal prongs when unplugging or
plugging in the cord.
1. The on/off switch (A) Fig. 10 is located on the front
of the planer moter. To turn the machine
"ON",
move
the switch up to the "ON" position.
2. To turn the machine
"OFF",
move the switch (A) down
to the "OFF" position.
OPERATIONAL CONTROLS AND ADJUSTMENTS
C
Fig. 10
A
