9
ATTACH MITER SAW TO STAND
ADJUSTMENT INSTRUCTIONS
If mounting bracket slots do not align with the saw
mounting holes, a 1/2” thick board may be used as a
mounting surface between the mounting brackets and
the saw.
To reduce risk of serious injury.
• Board must be at least 1/2” thick and wide enough to
extend beyond saw and mounting brackets.
• Make sure mounting hardware will not extend above
saw table or interfere with mounting brackets.
• Make sure all hardware and mounting brackets are
tightly secured before mounting saw.
Mounting brackets when slots do not align with saw mounting holes
1. Adjust left and right vertical T-supports as needed, to
support work piece on the saw, so that it is level with
the saw work table. Tighten lock knobs on receiver
tubes. See Figures 7 & 7a.
Failure to properly support
workpiece may result in serious
injury.
FIGURE 7
a
LOCK
KNOB
TIGHTEN
