4.
Place the gage block (A) Fig.
29,
underneath outfeed
roll (C). The bottom of outfeed roller (C) should just touch
the top of gage block (A) which would be
.035"
below the
cutting circle.
5.
If an adjustment is necessary, loosen locknut (0)
Fig.
30,
and turn adjustment screw (E) until the outfeed
roll just touches the top of gage block.
6.
Repeat the adjustment at the opposite end of outfeed
roller. Tighten lock nut (0) Fig.
30,
after adjustment is
made.
ADJUST CHIP DEFLECTOR
1.
DISCONNECT MACHINE FROM THE POWER
SOURCE.
2.
Remove two screws (A) Fig.
31,
and lift up on chip
chute (8).
3.
The edge (C) of the chip deflector (0) Fig.
32,
should
be adjusted so it is a minimum of
.040"
and a maximum
of
.080"
away from the cutting circle. Place a feeler gage
between the knife and the edge of the chip deflector as
shown in Fig.
32.
If an adjustment is necessary loosen
three screws (E) and move chip deflector.
Fig.
29
Fig.
30
Fig.
31
Fig.
32
13