TECHINCAL DATASHEET
LYTE DIN Rail Power Supply
24V 480W 1 Phase / DRL-24V480W1A
□
All parameters are specified at 25°C ambient and AC input unless otherwise indicated.
www.DeltaPSU.com (December 2020, Rev. 05)
11
Safety Instructions
Vertical Mounting
•
ALWAYS switch mains of input power OFF
before connecting and disconnecting the
input voltage to the unit. If mains are not
turned OFF, there is risk of explosion /
severe damage.
•
To guarantee sufficient convection
cooling, keep a distance of 50mm (1.97
inch) above and 18cm (7.09 inch) below
the device as well as a lateral distance of
10mm (0.39 inch) to other units.
•
Note that the enclosure of the device can
become very hot depending on the
surrounding air temperature and load of the
power supply. Risk of burns!
•
The main power must be turned off before
connecting or disconnecting wires to the
terminals.
•
DO NOT insert any objects into the unit.
•
Hazardous voltages may be present for up to
5 minutes after the input mains voltage is
disconnected. Do not touch the unit during
this time.
•
The power supplies are built in units and
must be installed in a cabinet or room
(condensation free environment and indoor
location) that is relatively free of conductive
contaminants.
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from