background image

 

I

NSTALLATION 

G

UIDE

Delta Network Thermostat: BACstat II

DNT-T221 (Rev 4.1)

Document Edition 1.8 

 

Product Description 

The DNT-T221 is an intelligent room thermostat with a custom 3-
value, 96 segment, LCD display.  The DNT-T221 can communicate on 
a BACnet MS/TP network or on Delta’s proprietary LINKnet network. 

The DNT-T221 can display a wide-range of digital or analog values, 
including setpoints, temperature, air flow, heating and cooling status, 
fan speed, valve and damper position, and more. 

When connected on a BACnet MS/TP network the DNT-T221 
functions as an independent BACnet thermostat.  When connected to a 
controller, on a LINKnet network, it provides a programmable remote 
sensor and expanded I/O capabilities. This version’s firmware can be 
flash loaded over the network, and has a termination resistor that is 
jumper selectable. 

 

 

 

Contents

 

MODEL NUMBERS............................................................................................................. 2 
PACKAGE CONTENTS ...................................................................................................... 2 
OTHER RELEVANT DOCUMENTS................................................................................. 2 
PRODUCT SPECIFICATIONS .......................................................................................... 2 
PCB BOARD LAYOUT........................................................................................................ 4 
JUMPERS .............................................................................................................................. 5 
MOUNTING .......................................................................................................................... 5 
WIRING DIAGRAM ............................................................................................................ 6 
POWER.................................................................................................................................. 7 
NETWORK CABLING & REQUIREMENTS .................................................................. 7 
NETWORK TOPOLOGY.................................................................................................... 8 
CAUTIONS & WARNINGS ................................................................................................ 9 
COMPLIANCE DECLARATIONS .................................................................................... 9 

 

Document Edition 1.8

 

 

Page 1 of 10

 

Summary of Contents for DNT-T221











Reviews: