Delta Compact Drive MS300 IP66/NEMA 4X Series, User Manual

Page: 9 / 135

Chapter 1 Introduction

MS300 (IP66 / NEMA 4X)
1-2
After receiving the AC motor drive, check for the following:
1. Inspect the unit after unpacking to ensure that it was not damaged during shipment. Make sure that
the part number printed on the package matches the part number indicated on the nameplate.
2. Make sure that the mains voltage is within the range indicated on the nameplate. Install the AC motor
drive according to the instructions in this manual.
3. Before applying power, make sure that all devices, including mains power, motor, control board and
digital keypad, are connected correctly.
4. When wiring the AC motor drive, make sure that the wiring for input terminals “R/L1, S/L2, T/L3”, and
output terminals “U/T1, V/T2, W/T3” are correct to prevent damage to the drive.
5.
When power is applied, use the digital keypad to select the language and set parameters. When
executing a trial run, begin with a low speed and then gradually increase the speed to the desired
speed.
1-1 Nameplate Information
NOTE
Service Link QR Code
Scan QR Code to apply for service
1. Locate the QR code sticker (as shown in Figure 1-1).
2. Use a smartphone to run a QR Code reader App.
3. Point your camera at the QR Code. Hold your camera steady so that the QR code comes into focus.
4. Access the Delta After Service website.
5. Enter your information in the column marked with an orange star.
6. Enter the CAPTCHA and click
Submit
to complete the application.
Cannot find out the QR Code?
1. Open a web browser on your computer or smartphone.
2. In the browser address bar, enter https://service.deltaww.com/ia/repair and press
Enter
.
3. Enter your information in the columns marked with an orange star.
4. Enter the CAPTCHA and click
Submit
to complete the application.
Figure 1-1