EtherCAT Communication Card: CMC-EC01
CMC-EC01 Operation Manual
6
3
Installation and Wiring
In this section, we illustrate how to connect CMC-EC01 to VFD-C2000 and the network
3.1 How to Install
How to connect CMC-EIP01 to VFD-C2000 series AC motor drive:
Switch off the power supply of VFD-C2000
Open the front cover of VFD-C2000
Place the insulation spacer into the positioning pin at Slot 1 (see Figure 1) and aim
the two holes on the PCB at the positioning pin. Press the pin to clip the holes with
the PCB (see Figure 2).
Crew up at torque 6~8 kg-cm [5.2~6.9 lb-in.] [0.59~0.78 Nm ] after the PCB is
clipped with the holes (see Figure3) .
Figure1
Figure 2
Figure 3
3.2 How to Disconnect
How to disconnect CMC-EIP01 from VFD-C2000
Switch off the power of VFD-C2000
Open the front cover of VFD-C2000
Remove the two screws (see Figure 4).
Twist open the card clip and insert the slot type screwdriver to the hollow to prize the
PCB off the card clip (see Figure 5).
Twist and open the other card clip to remove the PCB (see Figure 6).
Figure 4
Figure 5
Figure 6
DC-
DC+
+1
+2
B1
B2
CAUTION
CL001
禁止移除上蓋，
維修除外。
Do not remove
this cover,except
for servicing
警
告
B1 B2
DC+
+1
+2
DC-
M
直流共母?
3
DC-/DC+
MOTOR /
制? ? 阻
電源
POWER /
