7
Fig. 8
Fig. 9
Fig. 10
Fig. 11
2.
Align hole in upper support tube (G) Fig. 8, with
flange (H) located at the bottom connector (J) and fasten
support tube to flange with screw (K), flat washers (L),
and hex nut (M). NOTE: Flat washers will be positioned
on each side of flange.
3.
Place the remaining small clamp (D) Fig. 9, onto the
split end of angle support tube (F). Insert upper support
tube assembly (G) with connector (J) attached, and tighten
clamp (D) as shown assembled in Fig. 9.
ASSEMBLING
VA C U U M H O S E TO
D U S T C O L L E C TO R
1.
Place hose clamp (A) Fig. 10, onto one end of 4
diameter vacuum hose (B) and slide hose around con-
nector (C) as shown in Fig. 11. Tighten hose clamp (A).
G
H
K
L
L
M
J
D
G
F
J
A
B
C
A
