10
Fig. 16
Fig. 17
T H R E E P H A S E INSTALLATION
If the motor on your machine is wired for 200, 230 or 460 Volts, Three Phase, proceed
as follows when connecting your machine to an electrical power system.
1.
Remove screw (A) Fig. 15, and terminal strip cover
(B).
2.
Remove plastic covering (C) Fig. 16, that snaps into
terminal strip.
3.
Bring three phase power line through access hole in
bottom of terminal strip box and connect the three power
lines to terminals (D) Fig. 17, and the green ground wire
to ground screw (E).
4.
IMPORTA N T:The rotation of the cutterhead must be
in a clockwise direction when viewed from the left side of
the machine; that is, the knives must be rotating toward
the infeed table from the top. If the cutterhead rotation is
incorrect, disconnect the machine from the power source
and interchange any two of the three incoming power
lines connected to terminals (D) Fig. 17.
C
E
D
Fig. 15
A
B