20
Figure
53
Release locking handle (A). Push in micro-adjust knob (B)
to engage mechanism, then turn handle right or left for
precise settings. Release micro-adjust knob (B) and lock
handle (A).
Figure 54
The miter gage is equipped with a T-slot bar (A) that allows
it to extend past the front of table. The miter gage body (B)
can be turned right or left for angle cross-cutting. Loosen
lock knob (C), choose angle, and tighten lock knob. The
miter gage is also equipped with adjustable index stops at
90 degrees (D) and 45 degrees right and left (E).
Figure 55
Place a straight edge (A) across the table at both ends of
the table insert. The table insert
(B) should always be level with the table. If an adjustment
is necessary, turn the four adjusting screws (B), as
needed. The table is equipped with a finger hole (C) for
easy removal.
Fig. 53
Fig. 54
Fig. 55
Setting Fence Micro-Adjust
Adjusting Table Insert
DISCONNECT TOOL FROM POWER
SOURCE.
