Delta 36-477, Instruction Manual, Page: 38 / 53

38
Fig. 116
Fig. 117
Fig. 118
Fig. 119
ADJUSTING FENCE
90 DEGREES TO TABLE
The fence must be adjusted so that the face of fence (A)
Fig. 116, is 90 degrees to the table. To check if the fence
is 90 degrees to the table, place a square (B) on the table
with one end of the square against the fence, as shown.
If an adjustment is necessary, tighten or loosen one of
two screws (C) or (D) using the wrench supplied, until the
fence is 90 degrees to the table.
IMPORTANT: VERY
LITTLE MOVEMENT OF THESE SCREWS (C) AND (D)
IS NECESSARY TO MAKE THIS ADJUSTMENT
.
ADJUSTING CLAMPING
ACTION OF FENCE
LOCKING HANDLE
When the fence locking handle (A) is pushed to the
down position, as shown in Fig. 117, the fence body (B)
should be completely clamped to the guide rail. If the
fence body (B) is not completey clamped to the guide
rail when the handle (A) is in the position shown in Fig.
117, lift up on locking handle (A) Fig. 118, and slightly
tighten two adjustment plugs (C) using arbor wrench or
7/8 wrench. Adjustment plugs (C) should be tightened
an equal amount. Check to see if the fence body (B) is
completely fastened to the rail by pushing down on lock-
ing lever (A). Adjust further if necessary.
IMPORTANT: AFTER ADJUSTING THE CLAMPING
ACTION OF THE FENCE LOCKING HANDLE, CHECK
TO SEE IF THE FENCE IS PARALLEL TO THE MITER
GAGE SLOT AND ADJUST IF NECESSARY
.
REPOSITIONING MOTOR
FOR STORAGE
When the saw is not in use, the motor can be reposi-
tioned so it hangs straight down at the rear, enabling you
to move the saw against a wall. This can be accomp-
lished by removing the belt and repositioning the motor
and motor mounting plate, as shown in Fig. 119.
B
C
D
A
A
B
C
C
A
B