11
ADJUSTING SPRING PRESSURE OF
TABLE POSITIVE STOP
The rotating table has positive stops at the 90 degree
straight cut-off position and 22-1/2, 30 and 45 degree
right and left miter positions. To adjust the spring pres-
sure of the positive stops, tighten or loosen screw (A) Fig.
25.
NOTE:
Do not tighten screw (A) to the point where it
becomes difficult to rotate the table.
Fig. 25
OPERATING HINTS
1. Before cutting, make certain the miter and bevel angles are set and firmly locked in place.
2. Before cutting, determine that the workpiece is the right size for the saw.
3. Place the workpiece on the table and hold it firmly against the fence.
4. For best results, cut at a slow, even cutting rate.
5.
WARNING:
Keep hands out of path of saw blade. If the workpiece you are cutting would cause your
hand to be within hazard zone of the saw blade, the workpiece should be clamped in place before
making cut.
6. Never attempt any freehand cutting (wood that is not held firmly against the fence and table).
A
