9
ASSEMBLY
CUTTINGHEAD RAISING AND
LOWERING HANDWHEEL
1.
Insert key (A) Fig. 7, into keyway (B) of raising and
lowering shaft.
Fig. 7
Fig. 8
2.
Assemble handwheel (C) Fig. 8, to raising and lower-
ing shaft as shown. Make sure key, which was
assembled to shaft in
STEP 1
, is engaged with
keyway in hub of handwheel (C).
3.
Assemble decal (D) Fig. 8, to raising and lowering
shaft as shown.
4.
Fasten handwheel (C) Fig. 8, to raising and lowering
shaft using an M10 flat washer (E) and an M10 hex
nut (F) supplied.
5.
Assemble handle (G) Fig. 8, to handwheel (C) as
shown.
B
A
G
C
D
F
E
LIFTING THE MACHINE
1.
IMPORTANT: CARE MUST BE TAKEN WHEN
LIFTING THE MACHINE ONTO A STAND OR
WORKBENCH. THE PLANER IS VERY HEAVY
AND A MINIMUM OF FOUR PEOPLE WILL BE
REQUIRED TO LIFT THE MACHINE AS
FOLLOWS:
2. Raise the cuttinghead (A) Fig. 10, by turning the
raising and lowering handwheel (B) clockwise, and
insert two 6 or 8 foot long 2 x 4’s (C) between the
cuttinghead and table as shown. Lower the
cuttinghead just until it touches the 2 x 4 ‘s (C) Fig.
10, so that they are positioned solidly between the
table and cuttinghead. Then with two people on
each end of the 2 x 4’s, move the machine to its
desired location.
Fig. 10
C
A
B
6.
Loosen two head locking knobs, one of which is
shown at (G) Fig. 9, and turn handwheel assembly
(H) clockwise to raise head assembly. Remove the
protective shipping block (J).
Fig. 9
J
H
G
FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL THE
MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTION
MANUAL.
ASSEMBLY TOOLS REQUIRED
ASSEMBLY TIME ESTIMATE - 2~3 hrs.
1) - Open end wrench (10 and 12mm)
- provided
5) - Hex wrench (3mm)
- provided
2) - Open end wrench (14 and 17mm)
- provided
6) - Hex wrench (2.5mm)
- provided
3) - Hex wrench (6mm)
- provided
7) - 10, 12, 14, 17mm Sockets - not provided
4) - Hex wrench (5mm)
- provided
8) - 2 -
2 x 4’s
- not provided