Universal PMAC Lite
PMAC Lite E-Point Descriptions
17
PMAC-LITE E-POINT DESCRIPTIONS
E1 - E2: Machine Output Supply Voltage Configure
E Point and
Physical Layout
Location Description
Default
E1
E1
CAUTION:
The jumper setting must match the type of
driver IC or damage to the IC will result.
Jump pin 1 to 2 to apply +V (+5V to 24V) to
pin 11 of U26 (should be ULN2803A for sink
output configuration) JOPTO Machine
outputs M01-M08.
Jump pin 2 to 3 to apply GND to pin 11 of
U26 (should be UDN2981A for source output
configuration).
1-2 Jumper installed
E2
E1
CAUTION
The jumper setting must match the type of
driver IC, or damage to the IC will result.
Jump pin 1 to 2 to apply GND to pin 10 of
U26 (should be ULN2803A for sink output
configuration).
Jump pin 2 to 3 to apply +V (+5V to 24V) to
pin 10 of U26 (should be UDN2981A for
source output configuration).
1-2 Jumper installed
Summary of Contents for Universal PMAC Lite
