Delta OHM HD21ABE17, Operating Manual

Page: 38 / 48

HD21ABE17 - 38 - V2.0
N
OTES FOR THE BATTERIES USE
• At the first start up, it’s necessary to completely recharge the batteries.
•
The charge time of the batteries package is about 4 hours.
• The last of the batteries package in measurement working mode is about 8 hours.
•
A new Ni-MH batteries package reaches the maximum of its performance only after
being discharged and charged completely again at least twice or three times.
•
The batteries package autonomy depends on the instrument use. Even if the
instrument is in stand-by with the batteries package completely charges, it is
autonomously charged during the time.
• The batteries package can be charge and discharge hundred of times, but using
them the charge loses its own capacity. Replace the batteries package when the
autonomy is reduced at some hours.
•
Use only Delta Ohm batteries package code BAT-40 and recharge it using SWD10
battery charger or one that complies with the specifications indicated in the
technical data.
•
The Ni-MH batteries package lasts more if, sometimes, you act with cutting and
you completely discharge it.
• Extreme temperatures weigh negatively on the performances of the batteries
package.
R
EPLACEMENT OF THE BATTERY PACK
To replace the battery pack proceed as follows:
•
Disconnect the external power supply, if connected.
•
Remove, from the back of the instrument, the batteries compartment cover
unscrewing the screw.
• Extract the connector paying attention to not break the wires.
•
Remove the battery pack.
• Connect the new battery pack: the connector has a key that prevents a wrong
insertion.
•
Replace the pack in the batteries compartment.
•
Close the batteries compartment with the closing screw.
B
ATTERIES DISPOSAL
Recycle the batteries or throw them in a suitable manner.
Don’t throw the batteries to the waste.
Don’t throw the batteries into the fire.