Delta OHM HD21ABE17, Operating Manual

Page: 35 / 48

HD21ABE17 - 35 - V2.0
C
LEARING THE MEMORY
To clear the memory, use the Erase Log function. The instrument starts clearing the
internal memory; at the end of the operation, it goes back to normal display.
NOTES:
• Data transfer does not cause the memory to be erased: The operation can be
repeated as many times as required.
•
The stored data remain in the memory independently of the battery charge
conditions.
•
The direct connection between instrument and printer via a USB
connector does not work.
•
Some keys are disabled during logging. The following keys are enabled: MEM,
MENU, ENTER and ESC.
•
Pressing the MEM and MENU keys has no effect on the logged data if these keys
are pressed after starting the recording, otherwise the following is valid.
P
RINT
F
UNCTION
Press ENTER to send the measured data directly to the USB port, in real time. The
printed data units of measurements are the same as those used on the display. The
function is started by pressing ENTER.
The time interval between two consecutive prints can be set from 15 seconds to 1
hour. If the print interval is equal to 0, by pressing ENTER a single data is sent to the
connected device. If the print interval is higher than 0, the data transfer continues
until the operator stops it by pressing ENTER again.