Delta OHM HD 98569, Manual

Page: 17 / 72

- - 17
User Management
The user must identify himself or herself by entering a user name and password: The registered
user name is shown in all performed operations: Printing, logging, calibration...
The available users are:
Administrator, user_1, user_2, user_3
and
anonymous user
. The different
users have different usage levels: The
Administrator
is enabled to use all of the instrument
functions and assigns the password to the other users. The three users and the anonymous can
access only part of the functions.
Settings
The user management options are stored in the “
USER OPTIONS
” menu item.
When the instrument comes out of the factory, the only user stored is the administrator. The
password is “00000000”: The “
Menu >> User Options >> User Password
” function allows
modification of the administrator password.
To enable the user_1, user_2 and user_3, you must assign a different password (not “00000000”),
using the “User Password” function.
In order to do that:
1. Select the menu item “Menu >> User Options >> User Password”.
2. Select the desired user (e.g. User_1) using the
arrows, and confirm with ENTER.
3. Type the old password (“00000000” in a new instrument), and confirm with ENTER.
4. Type the new password (not “00000000”), and confirm with ENTER.
5. Select “Menu >> User Options >> User Registration” using the
arrows, and select
the new user to which you have just assigned a password.
6. Type the password, and confirm with ENTER.
Now the User_1 is enabled and can use the instrument: The printed and stored information will
show “Operator = User_1”.
Note: The passwords beginning with 27 (27000000 to 27999999) are reserved and you cannot use
them.
Access modes
If you wish the instrument to request the user selection and relevant password upon turning on, set
“Menu >> User Options >> User Exit Mode = Request New User”. When you turn the instrument
on you get all the users: Select the user using the
arrows, and type its password. Confirm
by pressing ENTER. The anonymous user does not need a password.
If you select “Recall User”, the instrument uses the previous user without requiring a password. In
this case, use the “User Registration” menu item to change the user (see points 5 and 6 above).
Note: The access mode can be modified only by the administrator.