Delta Heat DHOR20, Installation, Operation & Maintenance Manual

Page: 8 / 19

4
FIGURE 1 (Normal Position) FIGURE 2 (Position after door reversal)
1 Top Hinge
2 Screw (3)
3 Door
4 Bottom Hinge
5 Screw (3)
6 Frame
7 Hole Cover
•
Insert the lower door hinge in the right side, fix the lower right hinge by tightening all the
screws.
•
Remove the pin cap (9) from the right side of the upper frame of the door, and then
transfer it to the same location on the opposite side.
•
Put the door on the Lower Door Hinge (5), keep the door level, and then fix the upper
hinge (3) to the body (4) by using screws.
•
Put on the upper hinge cover (1).
OPERATING YOUR UNIT
➢
Setting the Temperature Control
•
Your unit has only one control for regulating the temperature in the compartment. The
temperature control is located on the upper right-hand side of the compartment.
•
The first time you turn the unit on, set the temperature control to
“6”.
•
The range of the temperature control is from position
“0” to “7”. After 24 to 48 hours, adjust
the temperature control to the setting that best suits your needs. The setting
“3” should be
appropriate for home or office use.
•
To turn the appliance off, turn the temperature control to
“0”.
NOTE:
•
Turning the temperature control to
“0” position stops the cooling cycle but does not shut off
the power to the unit.
•
If the unit is unplugged, has lost power, or is turned off, you must wait 3 to 5 minutes before
restarting the unit. If you attempt to restart before this time delay, the unit will not start.