EN
16
15
5/
Learning for the shutter travel time
Perform a complete cycle from stop to stop:
❶
Lower or raise the roller shutter completely to
the stop.
❷
Do the reverse action until the opposite stop is
reached.
Note
: The learning for the shutter travel time
adjusts itself automatically for each complete cycle
from stop to stop.Réglage manuel des temps de
courses du volet
Do not interrupt the roller shutter travel.
5.1 Manual adjustment for the shutter travel time
The learning for the shutter travel time adjusts itself
automatically for each complete cycle from stop to
stop.
If the motor has 4 wires (Live/Neutral/Raise/Lower)
or if the power of the connected motor is less than
45 W, this operation must be done manually.
5.1.1 Adjustment of shutter travel time
- Before making this adjustment, fully raise the
shutter with the local hard-wired control, a remote
control or a TYDOM and press Stop.
- Briefly press the button five times, then press the
button againfor 6 seconds, the LED is on and steady.
Release.
- The LED flashes six times.
- Press the receiver button for 3 seconds to confirm,
the LED then switches off.