The simple lighting mode can be associated with a
TYXAL detector (opening, movement, technical,
etc.).
Press the receiver button
until the LED flashes
(~3 seconds).
On the receiver, press the Test key (emits a beep).
Check that the receiver’s LED is no longer flashing.
The detector is associated with the receiver.
Simple lighting mode with
an associated TYXAL detector
ON
OFF
Lights switch off
at the end
of detection
Lights switch
on following
detection
The receiver can record up to a maximum of 8
associations (buttons, transmitters, etc.).
Press the Test button of the control unit.
The control unit emits a beep.
Check that the receiver’s LED is no longer flashing.
The control unit is associated with the receiver.
The simple lighting mode can be associated with a
TYXAL alarm control unit.
On the control unit, enable the Maintenance mode
(see control unit guide).
Press the receiver button
until the LED flashes
(~3 seconds). 2 possible choices.
Slow flashing: alarm transfer mode,
Rapid flashing: transfer of alarm activation or deacti-
vation mode.
Press the receiver
button to pass from one rate
of flashing to the other.
Alarm transfer
(light on
for 1.5 minutes
in the event
of an alarm)
Transfer of alarm
activation and
deactivation.
On: lights
flash once,
Off: lights
flash twice,
or
Simple lighting mode with an associated TYXAL control unit
Press down the receiver
button (after 3
seconds, the LED flashes). Keep pressing until the
LED extinguishes to confirm that all the receiver
associations are removed.
Removing all the Receiver
associations
The simple lighting mode can be associated with a
TYDOM transmitter.
To associate TYXIA 411 with the TYDOM 200 or
TYDOM 310, please refer to the respective guides.
Simple lighting mode with
an associated TYDOM transmitter
TYDOM 310 telephone transmitter
TYDOM 200 multifunction remote control
TYDOM 310 enables the ON/OFF
feature to be operated remotely.
TYDOM 200 includes all the functions
of the TYXIA buttons:
Troubleshooting
The purpose of this section is to help you quickly
solve the most common problems that you may
encounter with your product during use. If you're
unsure, or if the problem persists or isn't in this list,
contact our technical service department.
You cannot associate a transmitter with your
receiver.
The maximum number of transmitters that can be
associated with a receiver is 8. If this number is
reached, the LED flashes.
To exit this mode, press and hold down the recei-
ver button for 3 seconds.
Lights only come on for 1 second each time a
button is pressed.
The remote control switch mode is enabled.
Put the unit into simple lighting mode (refer to the
“Remote control switch mode” chapter).
The receiver does not recognise the command
from a transmitter.
• The transmitter is not associated with the receiver.
• The receiver is still in association mode.
• The transmitter batteries are low.
• 230 V, 50 Hz power supply, +/-10%
• Class II insulation
• Power consumption: 1 VA
• Maximum power: 6 A 230 Veff Cos
ϕ
= 1
• Radio frequency 868 MHz (standard EN 300
220)
• Radio range: 100 to 300 metres outside
depending on the equipment associated (the
range can be altered depending on the instal-
lation conditions and the electromagnetic envi-
ronment)
• Number of transmitters that may be associated
with the receiver: 8 max.
• Operating temperature: 0 to +40°C
• Storage temperature: -10 to +70°C
• Dimensions: 80 x 80 mm, height 45 mm
• Protection index: IP 40 - IK 04
• Installation in an environment with normal
pollution levels
Technical characteristics
