DELTA DORE TYDOM 1.0, Installation Instructions Manual

Page: 13 / 15

50 51
EN
D Remove an association (the removal method varies according to the
transmitter associated, refer to the transmitter's user guide)
Example of removing a remote control association.
On the receiver:
- Press the receiver button for 10 seconds until the LED flashes rapidly, release.
On the remote control:
- Press the and buttons for 3 seconds.
- Make sure that the receiver LED has stopped flashing. The products are no longer
associated.
E Remove all associations
- Press the receiver's button for 20 seconds.
- Press and hold until the LED switches off after the rapid flashing phase.
- Release. The receiver has no wireless connection.
F
Factory reset
- Press the receiver button for 30 seconds, the LED flashes then switches off,
The receiver has no wireless connection and the configuration is reset (mode 1 by
default).
5/ TROUBLESHOOTING 6/ TECHNICAL CHARACTERISTICS
6.1 TYXIA 2330 TRANSMITTER SWITCH
• Battery life of 10 years CR 2430
• Radio frequency 868,7 MHz to 869,2 MHz
• Maximum wireless power < 10 mW
• Category 2 receiver
• Wireless range: 100 to 300 metres outside, variable depending on the associated
equipment (the range can vary depending on the installation conditions and the
electromagnetic environment)
• Class III insulation
• Dimensions: 80 x 80 x 11 mm
• Degree of protection: IP 40, IK 04
• Operating temperature: -10 °C/+40 °C
• Storage temperature: -10 °C/+70 °C
• Installation in an environment with normal pollution levels