6
7
ASSEMBLY INSTRUCTIONS
3. If this fan is not replacing an old fan, be sure to cut
a 7 1/2in. x 7 1/4in. opening for the Fan Body
1
.
Make sure the 7 1/4 inch side of opening is flush
with the joist for installation from below.
4. Attach the Duct Connector
3
to the Fan body.
Remove the wiring box cover from the Fan
Body
1
. Remove the wiring knockout from the
wiring box cover with a flathead screwdriver (not
included). Remove the three screws that hold
the fan motor assembly in place. Remove the fan
motor assembly from the Fan Body
1
. Unplug
fan connector.
5. Remove the fan junction box cover. Using wire
nut(not supplied), connect house wires to fan wires
as shown in the wiring diagram on page 4. 14AWG
is the smallest conductor that shall be used for
branch circuit wiring. Reattach fan junction box
cover. Reattach fan junction box cover.
6. Install a circular 4 in. duct (not included) and
secure it with duct tape or clamps (neither
included).
Mount the Fan Body
1
to the joist or stud using
nails (not included) were indicated.
7. Plug the fan connector and fan assembly back
into the Fan Body
1
. Reattach the fan assembly
using the three screws removed in step 4.
wire nut
(not included)
Product
wires
House
wires
5
9.4"
9.4"
7 1/2 in.
7 1/4 in.
3
Tape
❶
Joist or wall stud
Nail
4 inch duct
6
1
3
4
7
