27
ASSEMBLY AND
DISMANTLING OF THE
SIDE RUNNER FRAMES
– Fit the side runner frames into the
holes on the side walls inside the
oven (Fig. 7.3).
– Slide the tray and rack into the run-
ners (Fig. 7.4).
The shelf must be fitted so that the
safety catch, which stops it sliding
out, faces the inside of the oven.
– To dismantle, operate in reverse
order.
Fig. 7.3
INSIDE OF OVEN
The oven should always be cleaned after
use when it has cooled down.
The cavity should be cleaned using a mild
detergent solution and warm water.
Suitable proprietary chemical cleaners
may be used after first consulting with
the manufacturers recommendations and
testing a small sample of the oven cavity.
Abrasive cleaning agents or scouring
pads/cloths should not be used on the
cavity surface.
•
NOTE
: The manufacturers of this appli-
ance will accept no responsibility for
damage caused by chemical or abra-
sive cleaning.
Attention: Do not store flamma-
ble material in the oven.
REPLACING THE OVEN LIGHT BULB
Switch the cooker off at the mains
. When the oven is cool, unscrew and replace
the bulb with another one resistant to high temperatures (300°C), voltage 230 V
(50 Hz), E14 and same power (check watt power as stamped in the bulb itself) of the
replaced bulb.
Note:
Oven bulb replacement is not covered by your guarantee.
Fig. 7.4