6
7
FIRST USE
"Easy wheel" system
Turn the radiator upside down on a rug or a soft surface in order
to prevent damaging the paint finish.
Fully unfold the wheels by turning them outwards (Fig. 1). Turn
the radiator back to its upright position.
Location
The heater must not be placed immediately below a power out-
let. Do not use this radiator in rooms having a surface area of less
than 43 square feet (4 sq.m.).
Power connection
Before using the appliance check that your supply voltage is
the same of that shown on the rating label of the unit and that
the power socket and power supply line correspond to the load
specified. After plugged in the appliance will shows the
symbol in red colour.
Setting the time
When using for the first time or after it has been unplugged for a
long time, you need to set the current time:
1. Plug the appliance into the mains. The display will show
00
blinking.
2. Turn the control dial to select the current hour.
3. When the correct hour is set, press the dial and the min-
utes digits will blink.
4. Turn the control dial to set the minutes then press the dial
to confirm.
Example of display:
❶
❸
❷
❹
Changing the time
If you need to reset the time, in manual operation mode press
the control dial for 5 seconds, then proceed as explained above.
After setting the clock, the unit will return in manual operation
mode.
MANUAL OPERATION MODE
Turn the appliance on pressing the button
.
The unit will start operating in manual operation mode with the
following default settings:
Setting the temperature
To modify the temperature set point, turn the dial clockwise to
increase and anticlockwise to decrease the temperature.
Temperature settings available are 5°C, and 10°C through to 28
°C.
Setting to 5°C turns the unit to the antifrost function. (see Anti-
frost function at page 6).
Selected power levels and working power levels
There are 3 power levels (min/med/max) as well as ECO mode.
min
med
max
max + eco
Depending on the selected power level, the working power level
may be less or equal to the selected power level.
The working heating power is always shown by the unit’s display
by means of the thin bars below the selected power level.
]
]
- If the current room temperature is much lower than the
selected temperature, the appliance will start to heat the
room as rapidly as possible at the selected power level.
- If the current room temperature is close to the selected
temperature, the appliance will heat the room using a
heating power lower than the selected power level.
- When the selected temperature is reached, the unit stops
heating.
Example: Operation is started at room temperature 18°C, the set
Fig. 1
Selected power level
Working power level
