16
medical attention immediately.
- WARNING: Chemical Burn Hazard. Keep batteries away
from children.
- Even used cells may cause injury.
- Do not dispose of batteries in fire. Batteries may
explode or leak.
SAFETY FUNCTIONS
-
Safety device:
the appliance is fitted with a safety
device that switches it off in the event of accidental
overheating (e.g. obstruction of air intake and outlet
grilles, motor turning slowly or not at all). To reset,
unplug the appliance from the outlet for a few
minutes, remove the cause of overheating, then plug
in again. If the appliance doesn’t work please contact
the De’Longhi Customer Service.
-
Tip-over safety device:
a tip-over safety device
turns the appliance off if it falls over or is positioned
inappropriately in such a way as to jeopardize safety.
The appliance emits a beep and a dot flashes on
the display.
The appliance resumes operation a few
seconds after being placed in an upright position
again.
Alarms
The appliance has a diagnostic system that makes it possible
to signal malfunctions.
In case of problems, the display will show an alarm message:
(Probe failure) and
(High temperature), see
troubleshooting section.
MAINTENANCE
- Always unplug from the outlet before cleaning.
- During the season when the appliance is in use, clean
the air intake and outlet grilles regularly using a
vacuum cleaner.
- To clean the filter, remove the rear grille by pulling it
outwards (fig. 1). Remove the dust filter that retains
impurities in the air drawn in from the room, blow on it
lightly then put it back in the appliance.
- Never use abrasive powders or solvents to clean the
appliance.
NOTE:
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. lf this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV
technician for help. Modifications not approved by
the party responsible for compliance could void user’s
authority to operate the equipment.
CAN ICES-3 (B) / NMB-3 (B)
