8
AIR CONDITIONING FUNCTION
The unit is turned off, the function selector
is in the “O” position. To turn the unit on in air
conditioning mode, proceed as follows:
1. Rotate the function selector dial clockwise:
•
Place the large star symbol in line with
the reference mark to operate the unit in
air conditioning mode at maximum fan
speed.
•
Place the small star symbol in line with
the reference mark to operate the unit in
air conditioning mode at minimum fan
speed.
2. Now set the required temperature by rota-
ting the room thermostat dial
.
Regulation of the thermostat
The temperature is not expressed in degrees.
We recommend that you turn the thermostat
dial to the maximum position. When the desi-
red room temperature has been reached,
slowly turn the thermostat in a clockwise
direction until it arrives at the position where a
click can be heard. The temperature selec-
ted in this way will automatically be regulated
and maintained, and save energy. When
regulating the thermostat, the air conditio-
ning function is temporarily interrupted and
the unit continues to operate in fan only
mode.
VENTILATION
Rotate the function selector
anticlockwise.
•
Place the large symbol in line with the
11
13
11
Turning on and Selecting functions
ELECTRICAL CONNECTION
Before plugging in check that:
•
the mains supply corresponds to the
power supply shown on the rating plate;
•
the socket and the mains lead correspond
to the power requirements of the applian-
ce;
•
the socket
is suited to the plug,
otherwise have the socket replaced;
•
the socket is properly earthed.
The manu-
factures cannot be held responsible for
any damages due to failure in following
normal safety procedures.
Replacement of the power cable must be
carried out by qualified personnel.
10
reference mark to operate the unit in air puri-
fication mode at maximum fan speed.
•
Place the small symbol in line with the
reference mark to operate the unit in air puri-
fication mode at minimum fan speed.
TURNING OFF
To turn the unit off completely, set the function selec-
tor to the “O” position and unplug from the mains
DELAY ON START UP
1 A special safety device will delay the
start of air conditioning by aproximately 3
minutes when switching between func-
tions or on initial start up.
2
You may also experience a slight delay
between changing from one function to
another.
THIS UNIT EMPLOYS AN EXCLUSIVE CON-
DENSATION RECYCLING SYSTEM TO DISPO-
SE OF EXCESS MOISTURE.
IN NORMAL CONDITIONS, CONDENSA-
TION IS DISPOSED OF AUTOMATICALLY.
WHEN THE HUMIDITY IS PARTICULARLY
HIGH, AN EXCESS OF CONDENSATION
MAY BUILT UP IN THE TANK
.. WHEN THIS
HAPPENS, THE INDICATOR LIGHT
.
COMES ON INDICATING THAT THE TANK
SHOULD BE EMPTIED.
ONLY FOR SOME MODEL IN EXTREME CASE
IF THIS PROBLEM IS CURRENT YOU MAY
DISCHARGE THE EXCESS WATER FROM THE
TANK
DIRECTLY INTO A DRAIN. USE THE
RUBBER TUBE WITH AN INTERNAL DIAMETER
OF 12 mm. THE TUBE SHOULD BE INSERTED
INTO THE HOLE PROVIDED AFTER REMO-
VING THE RUBBER BUNG MAKE SURE THE
TANK
. IS PUT BACK CORRECTLY
OTHERWISE THE LIGHT
. WILL REMAIN ON.
THE INTERNAL TANK CAN ALSO BE DRAINED
BY REMOVING THE BUNG FROM THE DRAIN
HOSE
INTO A SUITABLE RECEPTACLE.
9
12
8
8
12
8
5751005200NZ 29-09-2000 13:36 Pagina 8
