10
Self-diagnosis
SETTING THE TIMER
The timer can be used to delay appliance start up or shutdown. This avoids wasting elec-
tricity by not operating the appliance when it is not needed
.
How to program delayed start up
• Plug the appliance into an outlet and press the
ON/STAND-BY
button (
A
), then select
the desired operating mode and other settings (temperature, fan speed, etc).
• Press the
ON/STAND-BY
button (
A
) again: The appliance switches to stand-by mode
(the two central segments are displayed).
• Press the
TIMER
button (
D
). The last timer setting or the preset value
6.0
flashes on the display.
• Use the + (
E
) or - (
F
) buttons to set the number of hours delay before the appliance comes
on. During the first ten hours, you can select half hour intervals. For times greater than ten
hours, one hour intervals can be selected. If the + (
E
) or - (
F
) buttons are pressed for more
than 2 seconds, the time runs rapidly up to a maximum of 24 hours. Press the timer button
again within a few seconds to confirm the setting. If the setting is not confirmed within a
few seconds, the display resets to Stand-by. With the timer activated, the countdown
before the programmed start up time is displayed and the light (
H
) flashes.
To cancel the timer programming, press the timer button (
D
) again.
How to program delayed shutdown
• Delayed shutdown can be programmed in any operating mode (air
conditioning/dehumidifying/fan).
• Press the
TIMER
button (
D
). The last timer setting or the preset value
6.0
flashes on the display.
• Use the + (
E
) or - (
F
) button to set the number of hours delay before the appliance goes off.
During the first ten hours, you can select half hour intervals. For times greater than ten
hours, one hour intervals can be selected.
If the + (
E
) or - (
F
) buttons are pressed for more than 2 seconds, the time runs rapidly
up to a maximum of 24 hours.
Press the timer button again within a few seconds to confirm the setting.
When the timer is set, the light (
H
) flashes.
At the set time, the air conditioner shuts down and remains in stand-by.
To cancel the timer programming, press the timer button (
D
) again.
SELF-DIAGNOSIS
The appliance has a self diagnosis system to identify a number of malfunctions.
Error messages are displayed on the appliance display.
LOW TEMPERATURE
(frost prevention)
PROBE FAILURE
(sensor damaged)
FULL TANK
The appliance is fitted with a frost protection device to
avoid excessive formation of ice on internal components.
The appliance starts up again automatically when the
defrosting process is com
pleted.
If this is displayed, contact your local authorized service cen-
tre.
Empty the internal tank, see page 15 "End of season opera-
tions".
IF ... IS DISPLAYED
...WHAT SHOULD YOU DO?
