9
OPERATING INSTRUCTIONS
Fig.9
Fig.10
Then let the water flow out into the drip tray underneath, or alternatively use this water to fill
(and then empty) the cup to be used for the coffee, so as to pre-heat it.
2)
Unless preheated, do not use cups that are too thick, as they will absorb too much heat.
3)
Use cups that have been previously heated by rinsing them with hot water or alternatively
by leaving them for at least 20 minutes on the cup warmer tray on top of the machine with
the appliance on.
NOTE 4:
while the machine is making the coffee, the delivery can be stopped at any
time by pressing the button (Fig. 12) or button (Fig. 13), as previously selected.
NOTE 5:
as soon as delivery is complete, to increase the quantity of coffee, simply press
and hold the button (Fig. 12) or button (Fig. 13), as previously selected, until
reaching the desired quantity (this operation must be performed within 3 seconds from
the end of the delivery of the coffee from the spouts).
NOTE 6:
when the alarm comes on (chap. 12, point 1), the water tank must be fil-
led, otherwise the coffee cannot be made. The water tank can only be removed if the
milk frother is first positioned towards the centre of the machine. (It is normal for there
to be a little water left in the tank when the alarm comes on).
NOTE 7:
: the machine counts the number of cups of coffee made. Each 14 single cups (or 7
double cups), the light switches on steady (chap. 12 point 3), warning the user that the
grounds container is full and must be emptied and cleaned. Until the grounds container has
been cleaned, the light will remain on and the machine cannot deliver coffee.To clean the con-
tainer, open the service door on the front (pulling the handle, Fig. 15), the light flashes (see
para 12 point 9); remove the drip tray (Fig. 16), empty and clean. Empty and carefully clean
the grounds container, making sure to remove all the residues that may be deposited on the
bottom.Also dry the any drops of condensate that may have formed inside the machine under
the drip tray.
IMPORTANT: when removing the drip tray, the grounds container
MUST be emptied, even if it is not completely full. If this is not done, when next
making coffee the grounds container may fill over the maximum level and block
the machine with lumps of coffee grounds.
NOTE 8:
the grinder in the coffee maker may become worn over time and consequently
the coffee will change taste as it is ground more coarsely.
To resolve this problem, re-set the grinding coarseness on the coffee grinder by adjusting the
knob (Fig. 17) one click anticlockwise (as described in chap. 6).
NOTE 9:
if the machine is not used for a long period, the infuser must be cleaned, as
described in par. 10.2.
NOTE 10:
while the machine is delivering coffee, never remove the water tank. If it is remo-
ved, the machine will not be able to make the coffee and the "no water" light will flash. If you
try and make another coffee, the machine becomes noisy and does not make the coffee.To
reset the machine, turn the steam knob anticlockwise as far as it will go and run off water
from the cappuccino maker for a few seconds.
Fig.11
Fig.12
