DeLonghi KH390715CB-6A, Quick Start Manual

Page: 5 / 10

5
tion. Do not use the appliance in areas where
gasoline, paints, or other flammable liquids
are used or stored.
- It is normal for heater’s plug and cord to feel
warm to the touch. However, an excessively
hot or deformed plug or cord is not normal
and may be the result of a defective electri-
cal outlet. Defective outlets must be replaced
before using the heater. Plugging the heater
into a worn outlet may result in overheating
of the power cord or may cause the risk of fire.
- Do not place the heater near a bed because
objects such as pillows or blankets can fall off
the bed and be ignited by the heater.
Please note:
This symbol indicates recommendations and important
information for the user.
- If your radiator is equipped with a polyethyle-
ne tape used as a carry handle, remove it be-
fore connecting appliance to the outlet.
- Always disconnect the plug from the power
outlet when the appliance is not in use.
- Do not use the appliance outdoors.
- To completely turn off the appliance, push the
ON/OFF button, and then unplug the heater.
- Connect to properly polarized outlets only.
- Make sure that the plug is fully inserted into
the outlet. Wall outlets may deteriorate with
time, so check the plug periodically for signs
of overheating or deformation. If the outlet
has deteriorated, stop using it and have it re-
paired.
- Check that neither the appliance nor the po-
wer cord have been damaged during ship-
ping.
- Make sure that no styrofoam or other packing
materials remain in the appliance.
- Make sure that no pieces of polystyrene or
other packaging material have been left
between one element of the appliance and
another. It may be necessary to pass over the
appliance with a vacuum cleaner.
- The first time the appliance is used, run it at
the maximum power for at least two hours.
During this time, ventilate the room thorou-
ghly to eliminate the “new” smell released by
the appliance. It is completely normal for the
appliance to emit “creaking” sounds the first
time it is run.
- Extreme caution is necessary whenever the
heater is left operating unattended.
- Do not open the appliance. No user-servicea-
ble parts inside.
SAVE THESE
INSTRUCTIONS
THIS PRODUCT IS FOR HOUSEHOLD USE
ONLY
DESCRIPTION
(see figure on pag. 3).
A
Thermostat
B Switches
C Comfortemp button
D Cord holder
E
Wheel
USE
Electrical connection
- Before plugging the radiator into the outlet, check that
the voltage of your outlet electricity supply corresponds
to the value V indicated on the appliance and that the
socket and power line are appropriately dimensioned.
- This appliance complies with directive on electromag-
netic compatibility.
Models with “Easy wheel” sytem
Turn the radiator upside-down on a rug or a soft surface in
order to prevent damaging the paint finish.
Fully unfold the castors by turning them outwards (Fig.1).
Turn the radiator back to its upright position.
Important!
When in use, the radiator should always be kept vertical
(wheels at the bottom, controls at the top). Any other posi-
tion could be dangerous!
INSTRUCTIONS FOR USE
Switching on - off
Turn the thermostat dial clockwise to maximum.