EN
4.5.2 CHILDREN SAFETY
When the “Children Safety” function is activated, the surface
temperature of the appliance is lower than in normal operation in
the active mode (“Comfort“, “Night“,…) to avoid the risk of burns
caused by brief accidental contact.
To activate the function, press the “+” and “-”
buttons together and hold them both down
until the icon appears on the display.
To deactivate the function, repeat the same
operation.
”Children Safety” can be activated in all operating modes,
including “Overdrive (2h)”. The function cannot be activated
when the appliance is in “Standby”.
SETTING THE CURRENT DAY AND TIME
Before setting the custom programme, make
sure the time and day of the week are set cor-
rectly. If this is not the case, press the ”Mode”
button until the icon
is displayed.
Then press the “Mode” button again and hold
it down until the number indicating the day
flashes.
Adjust the day of the week by using the “+“
and “-“ keys (1=MON, 2=TUE,…7=SUN), then
confirm by pressing the “Mode“ selection key.
The hour starts flashing. In the same way, ad-
just the hour by using the “+“ and “-“ keys and
confirm with “Mode“ selection key.
Minutes are now flashing: repeat the same
procedure.
SETTING THE PROGRAM
Now an hourly sequence can be set for each day. Start with
the first day. Choose by means of the “+” and “-” buttons, for
each hour, between the “Comfort” temperature (full bar) and
the “Night” temperature (empty bar).
Press the “Mode“ key to confirm and repeat
the same procedure for each day of the week.
The weekly program is now set, the appliance
emits an acoustic signal for confirmation.
T Night
T Comfort
T Comfort
T Night
0h 2 4 6 8 10 12 14 16 18 20 22 24
4.5 FUNCTIONS
The appliance has a number of special functions to customise
and optimise use.
4.5.1 OVERDRIVE (2h)
The “Overdrive (2h)” can be used to heat the room quickly.
Press the “2h” button to start the “Overdrive
(2h)“.
The function cannot be activated when the
appliance is in “Standby”.
The temperature set point disappears from the display of the
remote control. The upper LED on the appliance turns red
and flashing. The lower LED turns red.
The appliance heats at the maximum power for 2 hours, in-
dependently from the temperature setting.
To deactivate the “Overdrive (2h)” function at any time, press
the “2h“ button again, the “Mode” button or the “Standby”
button.
The “Overdrive (2h)“ is set to stop automatically after 2 hours
anyways.
IMPORTANT:
If the appliance remains without power while
the “Overdrive (2h)“ function is enabled, the time remaining
until the end of the two hour period is retained for about one
and a half hours. After this time, when power is restored the
date and time settings are lost. The appliance exits the func-
tion and operates in the mode selected previously.
With the “P4” program, you can set different temperatures
(”Comfort” and ”Night”) over a 24 hour period for each day
of the week.
PROGRAM P4 - CUSTOM
7
