20
DISPLAYED MESSAGES
DISPLAYED MESSAGES
POSSIBLE CAUSE
SOLUTION
FILL TANK
Insufficient water in the tank (A20).
Fill the tank with water and/or insert it correct-
ly, pushing it as far as it will go until it clicks
into place.
EMPTY GROUNDS CONTAINER The grounds container (A15) is full.
Empty the grounds container and drip tray,
clean and replace. Important: when removing
the drip tray, the grounds container MUST be
emptied, even if it contains few grounds. If this
is not done, when you make the next coffees,
the grounds container may fill up more than
expected and clog the machine.
GROUND TOO FINE ADJUST
MILL
The grinding is too fine and the coffee is delive-
red too slowly or not at all.
Repeat coffee delivery and turn the grinding
adjustment dial (fig. 11) one click clockwise to-
wards “7” while the coffee mill is in operation.
If after making at least 2 coffees delivery is
still too slow, repeat the correction procedure,
turning the grinding adjustment dial another
click until delivery is correct (see the section:
“Adjusting the coffee mill on page 13). If the
problem persists, make sure the water tank is
fully inserted.
If the water softener filter is present, an air
bubble may have been released inside the cir-
cuit, obstructing delivery.
Deliver a little water until the flow becomes
regular.
INSERT GROUNDS CONTAINER After cleaning, the grounds container has not
been replaced (A15).
Remove the drip tray and insert the grounds
container.
ADD PRE-GROUND COFFEE
With the “pre-ground coffee” function selected,
pre-ground coffee has not been poured into the
funnel (A4).
Place pre-ground coffee in the funnel or dese-
lect the “pre-ground” function (fig. 16).
DESCALE
The machine must be descaled.
The descaling procedure described in the section
“Descaling” needs to be performed as soon as
possible (page 16).
REDUCE COFFEE AMOUNT
Too much coffee has been used.
Select a milder taste by pressing the
icon
(fig. 8) or reduce the quantity of pre-ground
coffee.
FILL BEANS CONTAINER
The coffee beans have run out.
Fill the beans container (fig. 12).
The pre-ground coffee funnel (A4) is clogged.
Empty the funnel with the help of a brush as
described in the section “Cleaning the pre-
ground coffee funnel” (page 16).
INSERT INFUSER ASSEMBLY
The infuser has not been replaced after clea-
ning (A19).
Insert the infuser as described in the para-
graph “Cleaning the infuser” (page 16).
Summary of Contents for ETAM29.62 SERIES
Page 1: ...ETAM29 62X BEAN TO CUP ESPRESSO AND CAPPUCCINO MACHINE Instruction for Use ...
Page 2: ...2 B C C2 C3 C5 C4 B2 B3 B4 C1 B1 B5 B6 B7 B8 B9 B10 B11 ...
Page 4: ...4 5 1 9 13 4 10 14 2 7 3 8 12 6 11 HOT MILK 15 16 ...
Page 5: ...5 29 25 26 22 18 30 27 23 31 28 24 20 17 19 21 22 23 P U S H P U S H ...
