10
Please note :
• When using the appliance for the first time, you need to
make 4-5 cups of coffee or 4-5 cappuccinos before the ap-
pliance starts to give satisfactory results.
5. TURNING THE APPLIANCE ON
Please note :
Before turning the appliance on, make sure the main switch
(A2-fig. 3)on the back of the appliance is in the
I
position.
Each time the appliance is turned on, it performs an automatic
preheat and rinse cycle which cannot be interrupted.
The appliance is ready for use only after completion of this cycle.
Danger of burns!
During rinsing, a little hot water comes out of the coffee spouts
(A18) and is collected in the drip tray underneath (A15). Avoid
contact with splashes of water.
• To turn the appliance on, press the
button (B1-fig.
4). The
(B2) and
(B4) lights flash while the
appliance is heating up and performing an automatic rinse
cycle. By circulating the hot water, the appliance heats the
boiler and the internal circuits. During this phase, the light
flashes.
When the
and
lights remain on steadily, the
appliance is at temperature.
6. TURNING THE APPLIANCE OFF
Each time the appliance is turned off, it performs an automatic
rinse cycle which cannot be interrupted.
Danger of burns!
During rinsing, a little hot water flows from the coffee spouts.
Avoid contact with splashes of water.
To turn the appliance off, press the
button (B1-fig. 4). The
appliance performs a rinse cycle then goes off.
Please note :
If the appliance is not used for an extended period, place the
main switch in the
0
position (A2-fig. 6).
Important!
To avoid damaging the appliance, never place the main switch
(fig. 6) in the
0
position while the appliance is on.
7. SETTING AUTO-OFF (STAND-BY)
The appliance is set by default to go off if not used for one hours.
The time can be changed so that the appliance switches off after
15 or 30 minutes, or after 1, 2 or 3 hours.
1. With the appliance off but the main switch in the l posi-
tion (A2-fig. 3), press and hold the
ECO
button (B16) until
the lights at the bottom of the control panel come on (see
image after point 2).
2. Select the required period of time (15 or 30 minutes or 1,
2 or 3 hours) by pressing the
(B7) button (see the
light/time table below).
15min
30min
1h
2h
3h
.
3. Press the
ECO
button to confirm the selection. Auto-off is
programmed.
Please note:
To disconnect the appliance completely, place the main switch
at the back of the appliance in the
0
position (fig. 6).
8. SETTING TEMPERATURE
If you want to modify the temperature of the water used to
make the coffee (low, medium, high, maximum), proceed as
follows:
1. With the appliance off (standby), but the main switch on
pos.
I
(A2-fig. 3), press and hold the
button (B3-fig.
11) until the lights on the control panel come on;
2. Press the
button (B5-fig. 12) to select the requi-
red temperature:
LOW
HIGH
3. Press the
button to confirm; the lights go off.
9. ENERGY SAVING
Use this function to activate or deactivate energy saving mode.
This reduces energy consumption in compliance with current
European regulations.
To activate the function, press the
ECO
button (B16), the light
(B17) comes on. To deactivate the function, press the
ECO
but-
ton. The light goes off.
Please note:
A few seconds may elapse between energy saving mode and
delivery of the first coffee as the appliance must heat up again.
Summary of Contents for ESAM 04.110
Page 1: ...5713212551 06 09 ...
Page 2: ......
Page 4: ...4 4 1 2 3 5 4 6 7 9 8 10 11 13 12 14 15 ...
Page 5: ...5 5 17 16 18 21 20 22 19 ...
