DeLonghi ECAM45.32X, Instructions For Use Manual

Page: 15 / 22

14
Danger of burns!
Stop steam delivery before removing the container with the
frothed milk to avoid burns caused by splashes of boiling milk.
9. Add the milk froth to the coffee prepared previously. The
cappuccino is ready. Sweeten to taste and, if desired, sprin-
kle the froth with a little cocoa powder.
Please note!
If “Energy saving” is active, you may have to wait a few seconds
before steam is delivered.
Making hot milk (not frothed)
To make hot milk without froth, proceed as described in the
above section, making sure the cappuccino/hot milk ring on
the cappuccino maker is positioned upwards in the “HOT MILK”
position.
Cleaning the cappuccino maker after use.
Clean the cappuccino maker each time you use it to avoid the
build-up of milk residues or blockages.
Danger of burns!
When cleaning the cappuccino maker, a little hot water is deli-
vered. Avoid contact with splashes of water.
1. Deliver a little water by pressing the button. Press
the same button again to stop the flow of hot water.
2. Wait a few minutes for the cappuccino maker to cool down.
Turn counter clockwise the cappuccino maker downwards to
remove it (fig. 21).
3. Move the cappuccino/hot milk ring upwards (fig. 22).
4. Slide the nozzle downwards (fig. 23).
5. Make sure the two holes shown by the arrows in fig. 24 are
not blocked. If necessary, clean with a pin.
6. Replace the nozzle, move the ring downwards and put the
cappuccino maker back on the nozzle (fig. 25), turning it
anticlockwise and pushing it upwards until it is attached.
DELIVERING HOT WATER
Important! Danger of burns.
Never leave the machine unsupervised while delivering hot
water.
The hot water spout becomes hot while water is being delivered
and must be held by the handle or black ring only.
1. Place a container under the spout (as close as possible to
avoid splashes).
2. Press the button (fig. 3). “HOT WATER” is displayed,
together with a progress bar which fills gradually as prepa-
ration proceeds.
4. The machine delivers 250 ml of hot water, then delivery
stops automatically. To interrupt delivery of hot water ma-
nually, press the
button again.
Please note!
If “Energy saving” is active, you may have to wait a few seconds
before hot water and steam are delivered.
Changing the quantity of water delivered
automatically.
The machine is set by default to automatically deliver 250 ml of
hot water. To modify these quantities, proceed as follows:
1. Position a container under the spout.
2. Press and hold the
button until “Hot water Pro-
gram quantity” is displayed, then release the .
3. When the hot water in the cup reaches the required level,
press the button again.
The machine is now reprogrammed with the new quantity.
CLEANING
Cleaning the machine
The following parts of the machine must be cleaned regularly:
- coffee grounds container (A12),
- drip tray (A14),
- water tank (A18),
- coffee spouts (A7),
- cappuccino maker (A8)
- pre-ground coffee funnel (A4),
- the infuser (A17), accessible after opening the service door
(A16),
- control panel (B)
Important!
• Do not use solvents, abrasive detergents or alcohol to clean
the appliance.
With De’Longhi superautomatic coffee machines, you need
not use chemical products to clean the machine.
• Do not use metal objects to remove encrustations or coffee
deposits as they could scratch metal or plastic surfaces.
Cleaning the coffee grounds container
When “EMPTY GROUNDS CONTAINER” is displayed, the grounds
container must be emptied and cleaned.
Until the grounds container has been cleaned, the appliance will
not make coffee.