DeLonghi DEGHBG60, Installation And Service Instructions Manual

Page: 27 / 32

27 27
BURNERS
■ These parts can be removed and cleaned with appropriate products.
■ After cleaning, the burners and their flame spreaders must be well dried and correctly
replaced.
■ Check that the electrode/s “ S ” (figs. 16a, 16c, 16d, 16e) next to each burner is/are
always clean to ensure trouble-free sparking.
■ Check that the probe/s “ T ” (figs. 16a, 16c, 16d, 16e) next to each burner is/are always
clean to ensure correct operation of the safety valves.
■ Both the probe and ignition plug must be very carefully cleaned.
■ Note: To avoid damage to the electric ignition do not use it when the burners are
not in place.
CORRECT REPLACEMENT OF THE AUXILIARY, SEMI-RAPID AND RAPID
BURNER (the rapid burner is available for the models DEGHBG70,
DEGHGB90 only)
It is very important to check that the burner flame spreader “ F ” and the cap “ C ” have been
correctly positioned (see figs. 16a and 16b). Failure to do so can cause serious problems.
■ They shall be level and the flame spreader must not rotate.
CORRECT REPLACEMENT OF THE TRIPLE-RING COMPACT (model
DEGHBG60 only), TRIPLE-RING (model DEGHGB70 only) AND DUAL
BURNER (model DEGHBG90 only)
It is very important to check that the burner flame spreader “ F1 ”, “ F2 ” or “ F3 ” and the caps
“
A
”, “
B
” have been correctly positioned (see figs. 16c, 16d, 16e, 16f, 16g). Failure to do so
can cause serious problems.
■ Fit the flame spreader to the housing: the burner ribs must be fitted in their housing as
shown by the arrows (see figs. 16c, 16d or 16e).
■ Then position the cap “ A ” and the ring “ B ” (see fig. 16f).
■ They shall be level and the flame spreader must not rotate (see fig. 16g).
Figure 16a Figure 16b
S
F
C
T