20
2. FILLING THE WATER TANK
Please note:
Before first use,
wash all the accessories and water tank with
warm water.
1. Extract the tank by pulling it upwards (fi . 1).
2. Open the lid and fill the tank with fresh clean water, taking
care not to exceed the MAX level (fi . 2). Put the tank back
in the appliance, pressing lightly to open the valves located
on the bottom of the tank.
3. More simply, the tank can also be filled without removing
it, pouring the water directly from a jug.
Important:
Never operate the appliance without water in the tank or with-
out the tank.
Please note:
It is normal for there to be water in the space under the tank.
This should therefore be dried regularly with a clean sponge.
3. FIRST USE
At first us , rince the internal circuit as follows:
1. Turn the appliance on by pressing the ON/OFF switch (fi .
3). The appliance performs a self-diagnosis cycle, indicated
by sequential flashing of the th ee buttons.
2. The
and
lights flash to indicate the appliance
is heating up. When the lights stop flashing and emain on
steadily, the appliance is ready for operating the rinse.
3. Attach the fil er holder to the appliance (fi . 9).
4. Place a container with a minimum capacity of 500 ml
under the boiler outlet (A5) (fi . 4) and press the
button. Repeat this operation 5 times.
5. Empty the container and put it under the hot water/steam
spout (A12) (fi . 4).
6. Turn the hot water/steam dial to the
position (fi .
5) and deliver to empty the water tank (A3); then turn the
knob to the
○
position.
4. PROGRAMMING THE SETTINGS MENU
To access the menu, make sure the appliance is ready for use,
then press and hold the
button for 10 seconds until the
three buttons flash in sequen e:
The appliance is now in programming mode.
Set the c
off
ee maker as you wish, then exit the settings menu by
waiting for 15 seconds.
Please note:
If no selections are made for 15 seconds, the appliance automat-
ically exits programming and is ready for use again.
4.1 Setting coffee temperature
To modify the temperature of the water used to make the c
off
ee,
proceed as follows:
1. Access the settings menu;
2. Press the
button to enter the c
off
ee temperature
selection mode. The lights corresponding to the current
selection come on:
low
medium
high
3. The lights start flashing in sequen e;
4. Press the button corresponding to the required
temperature:
low
medium
high
5. The
button flashes to indicate that the selection has
been saved.
The appliance exits the menu and is ready for use.
4.2 Setting water hardness
The light (B7) indicating that the c
off
ee maker needs descaling
comes on after a period of operation established according to
water hardness.
The appliance can also be programmed according to the hard-
ness of the mains water in the various regions so that descaling
needs to be performed more or less frequently.
Proceed as follows:
1. Access the settings menu;
2. Press the
button to enter the water hardness selec-
tion mode. The lights corresponding to the current selec-
tion come on:
soft
medium
hard
3. The lights start flashing in sequen e;
4. Press the button corresponding to the water hardness in
your area:
