27
INSIDE OF OVEN
The oven should always be cleaned after use when it has cooled down.
The cavity should be cleaned using a mild detergent solution and warm water.
Suitable proprietary chemical cleaners may be used after first consulting with the manufac
-
turers recommendations and testing a small sample of the oven cavity.
Abrasive cleaning agents or scouring pads/cloths should not be used on the cavity surface.
NOTE:
The manufacturers of this appliance will accept no responsibility for damage cau-
sed by chemical or abrasive cleaning.
Do not store flammable material in the oven.
Let the oven cool down and pay special attention no to touch the hot heating ele-
ments inside the oven cavity.
GRILL HEATING ELEMENT
■
The heating element is self-cleaning and does not require maintenance. The grill is
secured to the rear wall of the oven on a hinge system that allows it to be lowered to
allow proper access when cleaning the oven ceiling (fig. 11 at page 15).
GREASE FILTER
■
Clean the filter after any cooking! The grease filter can be removed for cleaning and
should be washed regularly in hot soapy water (fig. 10 at page 15).
■
Always dry the filter properly before fitting it back into the oven.
REPLACING THE HALOGEN OVEN LIGHT
WARNING: Ensure the appliance is
switched off before replacing the lamp
to avoid the possibility of electric shock.
■
Let the oven cavity and the heating ele-
ments to cool down.
■
Switch off the electrical supply.
■
Remove the protective cover “
C
” (fig.
23).
■
Replace the halogen lamp “
B
” with a
new one suitable for high temperatures
having the following specifications:
220-
240V or 230-240V, 50 Hz and same po
-
wer (check watt power as stamped in
the bulb itself) of the replaced lamp.
IMPORTANT WARNING: Never repla-
ce the lamp with bare hands; conta-
mination from your fingers can cau
-
se premature failure. Always use a
clean cloth or gloves.
■
Refit the protective cover “
C
”.
NOTE:
Oven bulb replacement is not cove-
red by your guarantee.
WRONG
CORRECT
B
C
Figure 23