5
1) Remove the continuous drain cap
1
by turning
it counterclockwise then remove the rubber
stopper
2
from the spout (fig. 2).
Note
: Some leakages from the spout could hap-
pen when removing the rubber stopper
2
(fig. 2)
.
2) Insert the drain cap
1
in the condensate drain
hose (8) till the end (fig. 3) then screw the
cap into the spout. (fig. 4).
3) Make sure the end of the hose is no higher
than the spout (Fig. 3) or water could remain
in the tank. Make sure there are no kinks in
the hose (Fig. 5).
Keep the rubber stopper to close
the spout.
C) Continuous draining using the
pump (only on pump models)
The patented heavy-duty pump system allows
water removal of up to 13 ft (4m) in height.
If you want the water to flow directly to a drain,
connect the condensation discharge tube supplied
(9) to the connection pipe located on the
lower front part of the unit unit (you will first need
to remove the stopper labeled PUMP) (fig. 6).
Select the dehumidifying function and press the
PUMP button.
Note
: With the condensation discharge hose
missing and the pump switched ON, the display
will show the symbol PUMP blinking.
To eliminate this problem:
•
Check the hose is correctly positioned;
•
Disconnect and reconnect the plug.
1
1
2
2
fig. 2
fig. 3
fig. 1
fig. 5
fig. 4
1 PUSH
2
fig. 6
