Delmhorst F-2000R, Operation Manual, Page: 3 / 12

3
FEATURES

6% to 40% moisture range for reed

For use on plywood and chipboard

Digital readout

Built-in calibration check

Temperature stable circuit

Averages up to 100 accumulated readings

Displays average and highest of accumulated readings

Ergonomic case design

Includes (1) 9-volt battery

Three year warranty

Over 65 years of proven quality, accuracy and service
BEFORE YOU BEGIN
BUTTON FUNCTIONS
Read (#1): Reads the percent moisture content value %MC.
Calibration
Check (#2) Checks the meter calibration. Displays the average of up to 100
accumulated readings; displays the highest
stored reading; erases the readings
Set Point
Decrease (#3): Acts as an arrow button when pressed after the set-point button
to decrease the set point to a lower value.
Set-Point (#4): Displays the current set-point. Also acts as an arrow (scroll)
button to increase the set-point value in 1% increments.
When the battery is replaced, the meter displays its software version for
one second and then turns itself off. After replacing the battery, you
must reset the meter as described below in the “Resetting the Meter”
section.
NOTE, we recommend NOT to use a rechargeable battery and advise to
only use ‘ALKALINE’ batteries.