Site Selection
•
WARNING
! Pools installed on inadequately level surfaces are subject to leaking, forming irregularities, or collapse, which can result in property
damage or serious injury for those in or around the pool area!
•
WARNING
!
DO NOT
use sand during setup process. If it appears that there is a need for use of a “levelling agent”, then your set-up site is
unsuitable.
•
FAILURE
TO
OBEY
THIS
WARNING
MAY
RESULT
IN
SERIOUS
PERSONAL
INJURY
.
•
CAUTION
: Please choose your set-up area carefully, as lawn and other desirable vegetation underneath the ground sheet (if applicable) will die.
Furthermore, try to avoid setting the ground cloth (if applicable) in areas prone to aggressive plant and weed species, as they may grow through
the ground cloth (if applicable).
•
CAUTION
: The pool must be accessible to a 110 or 230-volt
AC
outlet protected by a Ground Fault Circuit Interrupter (
GFCI
). The pool should be
set no closer than 2 m to the power source, but no further than the length of the filter pump cord. Under no circumstances should an extension
cord be used to extend the range of the connection.
• It is absolutely essential to select a suitable site for your pool
BEFORE
attempting to fill it with any water. Please select a set-up site which strictly
conforms to the following guidelines:
•
1. Ensure that the area is firm, flat (no bumps or mounds of earth) and extremely level, with a grade not exceeding 3° of slope at any point in the
set-up area.
• 2. Make sure that the area you have selected to set-up the pool is completely free of sticks, stones, sharp objects or other foreign debris.
• 3. Select an area that is not directly underneath overhead power lines or trees. Additionally, make sure that the pool set-up area does not contain
underground utility pipes, lines, or cables of any kind.
• 4. If a ground cloth is provided with your pool kit, its use, is highly recommended. The ground cloth will help protect the pool liner from damage
due to weed growth, sharp objects, and debris.
• 5. If at all possible, choose an open location on your property that is exposed to direct sunlight. This will help to warm your pool.
Pool Setup
•
IMPORTANT
:
DO NOT
start assembly if any pieces are missing. For replacement pieces call the Dellonda Service telephone number.
• The number of adults required for installation: at least 2 adults.
•
Total installation time except the time for site preparation and water filling:
approximately 60 minutes.
• Step 1.
ACCOUNT
FOR
ALL
PARTS
.
• Remove all the parts from the carton(s) and place them on the ground in the location where they are to be assembled Check each part according
to “
CONTENTS PAGE
” make sure all the pieces to be assembled are accounted for.
• Step 2.
INSTALL
DRAIN
VALVE
COVERS
AND
STOPPER
• Make sure that the outer drain plug is inserted into the outer drain cap and the drain valve cover is screwed on tightly. Plug the connection holes
with the stoppers. (The out drain plug changes according to different size of pool.)
• Step 3.
INSTALL
THE
U-
TUBES
