5.4.
STEP 4
5.4.1.
Place the tank housing over the post.
5.5.
STEP 5
5.5.1.
Remove four bolts from the base of the burner.
5.5.2.
Pass the gas hose down through the post.
5.5.3.
Fix the burner to the post, use bolt DD. Tighten nuts and bolts.
5.6.
STEP 6
5.6.1.
Place large washers GG on the 3 reflector spacers FF.
5.7.
STEP 7
5.7.1.
Fix the reflector onto the reflector spacers use 3 x wing nut KK.
5.8.
STEP 8
5.8.1.
Raise the tank housing and rest it on the post plate. Be aware that it
may fall if it is knocked.
5.8.2.
Connect the gas hose to the regulator.
5.8.3.
Place the LPG cylinder on the stand.
6. OPERATION
6.1.
CONNECT GAS CYLINDER
6.1.1.
Change the gas cylinder in a well ventilated area, away from any source
of ignition.
6.1.2.
Lift the tank housing and prop it up on the top of the post brackets.
NOTE:
In this instance the housing can not be propped up on the
top of the post brackets. A second person will be required to hold the
tank housing up while the gas cylinder is fitted.
6.1.3.
Check the regulator seal is correctly fitted and working correctly, see fig.2.
6.1.4.
Use propane or butane only.
6.1.5.
Only use hose and regulator supplied with heater.
6.1.6.
Never use a gas cylinder with a damaged valve or a damaged cylinder.
6.1.7.
Never connect an unregulated cylinder to the heater.
6.1.8.
GAS LEAKAGE
6.1.9.
In the event of gas leakage
DO NOT
use the heater. The gas supply
should be shut off and the cause should be investigated before it is used
again.
fig.2
Step 4
Step 5
Step 6
Step 7
Step 8
Original Language Version
D
G96, DG97 Issue:1 24/12/20
