20
INSTALLATION INSTRUCTION (INDOOR UNIT)
BEFORE INSTALLING
• The indoor unit should installed 250cm (98”) or more
above the floor.
• Do not install your air conditioner in wet room such as
bathroom or laundry room etc.
MOUNTING PLATE INSTALLATION
• Install the mounting plate horizontally or slightly tilted
down toward the side of drain hose. If it is tilted above
the drain hose side, condensed water may overflow.
1. Drill 32mm (1.25”) deep holes in the wall.
2. Insert plastic anchors into the holds;
3. Fix the mounting plate on the wall and firmly secure it
using the provided tapping screws.
WALL PIPING INSTALLATION
1. Drill a piping hole (Φ65) in the wall at a slight
downward tilt towards the outdoor side.
2. Insert the piping hold sleeve through the hold.
NOTE: Keep the drain pipe tilted downward through the
hole to prevent condensed water leakage / overflow.
INDOOR UNIT ELECTRICAL CONNECTIONS
1. Open the front panel.
2. Take off the terminal block cover by removing the
screw or breaking the hooks.
3. Connect the cable wires according to the circuit
diagram which located on the right part under the
front panel.
4. Use wire size suitable to the electric power input and
follow all national safety code requirements.
The cable connecting the indoor and outdoor units
must be suitable for outdoor use.
The plus should remain accessible after the appliance
has been installed.
Ensure an efficient earth connection.
