DELLA 048-GM-48293, User Manual

Page: 10 / 11

9
PROBLEM POSSIBLE CAUSE SOLUTION
“ ”
symbol is
lightening on and the
arrow flashes.
Lack of Water.
Stop the ice maker, fill water, and
press
“ON/OFF” button again to
restart the unit.
“ ” symbol is lightening
and letter
“F” flashes.
There is too much ice.
Suggest you to obtain the
ice-cube.
No ice cube inside.
Remove the probable obstacle
inside or clean the inside wall of
the ice storage, if still can
’t start to
ice making process, press
“SELECT” for more than 5
seconds to run the ice making for
10 cycles at most.
Ambient temperature
sensor breakdown
The unit can still work, but
suggest to call the manufacturer
service man or electrical
technician to change to a new
sensor.
The ice-making box can
not reset normally.
Call the manufacturer service man
or qualified technician to check
the problem.
Ice cubes on the
evaporator stick together.
The ice cycle is too long.
Stop the ice maker, and restart it
after the ice blocks melt. Select
the small size ice cube selection.
Water temperature in inner
tank is too low.
Change the water in the inner
Tank. Temperature of water is
better set between
45-90
Fahrenheit degree .
There are ice-cube inside
the unit, but can
’t
dispense the ice-cube
when you push the
“ICE”
button.
Moving shaft for the
Ice-cube is blocked.
Release the button for ice-cube
for 3 seconds, then again push
the
“ICE” button.
Ice making cycle is normal
but no ice is made.
Ambient temperature or
water temperature in inner
tank is too high.
Please run the ice maker below
90 Fahrenheit degree ambient
and pour colder water into tank.
Refrigerant liquid leakage. Verify by a qualified technician.
Pipe in the cooling system
is blocked.
Verify by a qualified technician.
TROUBLESHOOTING