Installing WES7p Firmware
11
11.
Select the USB key onto which you want the configurations (you can use
Refresh
as
needed to recognize an inserted USB key), and then click
Next
. The progress bars
show the overall (formatting and configuration) progress and task progress.
CAUTION
: DO NOT interrupt the formatting and configuration process. All process
requirements are done automatically.
12.
After configuration, click
Finish
to close the wizard and then remove the configured
USB key for use (you will use the configured USB key on your target devices).
TIP
: At this time you can also replicate/duplicate the configured USB key (containing
the firmware you want to push) for simultaneous usage on target devices (by users in
several locations at the same time). For full Wyse USB Firmware Tool details, see Users
Guide: Dell
®
Wyse USB Firmware Tool 1.20.0.1.
Step 4: Use the Configured USB Key to Install Firmware on Each Thin Client
In this step, you will boot each target device you want to convert from the configured
USB key so that the USB key will push the contents from the USB key onto the target
device.
NOTE
: BIOS selection, movement, and exit instructions are displayed in the BIOS
window.
1.
Be sure the client is shut down and disconnected from any network.
2.
Attach the configured USB key to a thin client USB 2.0 port.
3.
Power on the thin client and during boot, press and hold the
P
key to boot to the
BIOS screen.
4.
Enter the password
Fireport
(this is case sensitive) and press
Enter
.
5.
Select the
Advanced
tab.
6.
Using the down arrow key, select the
Boot from USB
option and press
Enter
.
7.
Select the
Enabled
option and press
Enter
.
8.
Select the
Boot
tab.
9.
Select the
USB HDD
option (displaying your USB key vendor name) and move it to the
Boot Priority Order
1
position by using the + key.
10.
Press the
F10
key to save, exit, and reboot the client from the configured USB key.
When booting a
target
device from the configured USB key (
containing the contents to
be pushed to a target device
), you will be prompted to continue with the
push
process
(to continue, type
y
and press
Enter
). Once the
push
process is complete, the client
automatically reboots several times.
CAUTION
:
DO NOT
interrupt the installation/conversion process. All process
requirements are done automatically. The client automatically reboots several times.
Some screens may display for several seconds during the process.
11.
After a target device completes the installation/conversion process and displays the
WES7p desktop, remove the USB key and continue with "Step 5: Verifying Thin Client
Operation."
TIP
: You can use the configured USB key to push the firmware onto as many target
devices as you want (repeat "Step 4: Use the Configured USB Key to Install Firmware on
Each Thin Client").
