Dell Networking W-AP270 Series Outdoor Access Point
| Installation Guide
9
Metal
Microwave ovens
Wireless phones and headsets
Installing the AP
Using the Mounting Kits
The W-AP270 Series access point can be installed on a wall or attached to a pole using one of the following
mounting kits:
Grounding the AP
After the W-AP270 Series access point is installed using one of the mounting kits above, the grounding must be
completed before powering up the access point. The grounding wire should be #8 AWG.
1. Peel the cover of one end of the grounding wire and place the bare grounding wire into the included copper
lug, and press firmly with the crimping pliers.
2. Fasten the copper lug to the grounding hole on the W-AP270 Series access point with the M4 x6 screw
included in the AP package as shown in
.
Figure 9
Grounding the AP
NOTE: Service to all Dell products should be performed by trained service personnel only.
Table 4
Applicable Mounting Kits for W-AP270 Series access point
Part Number
Description
AP-270-MNT-V1
Long mounting kit for wall and vertical pole mounting, 300 mm from vertical mounting asset.
AP-270-MNT-V2
Short mounting kit for wall and vertical pole mounting, 75 mm from vertical mounting asset.
AP-270-MNT-H1
Mounting kit for hanging from inclined or horizontal structure.
NOTE: The W-AP270 Series access point does not ship with any mounting kits. These mounting kits are available as accessories
and must be ordered separately.
NOTE: For installation instructions on AP-270-MNT-V1, AP-270-MNT-V2 and AP-270-MNT-H1, please refer to the
AP-270-MNT-V1
Installation Guide, AP-270-MNT-V2 Installation Guide
and
AP-270-MNT-H1 Installation Guide
respectively
.
