Back to Contents Page
Wireless Mini-Card
Dell™ Vostro™ A90 Service Manual
Removing the Mini-Card
Replacing the Mini-Card
If you ordered a wireless Mini-Card with your computer, the card is already installed.
Your computer supports one full Mini-Card slot for Wireless Local Area Network (WLAN).
Removing the Mini-Card
1.
Follow the instructions in
Before You Begin
.
2.
Remove the module cover (see
Removing the Module Cover
).
3.
Disconnect the antenna cables from the Mini-Card.
4.
Release the Mini-Card by removing the securing screws.
5.
Lift the Mini-Card out of its system board connector.
CAUTION:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTICE:
To help prevent damage to the system board, you must remove the battery from the battery bay before you begin working inside the
computer.
NOTE:
Dell does not guarantee compatibility or provide support for Mini-Cards from sources other than Dell.
NOTE:
Depending on the configuration of the computer when it was sold, the Mini-Card slot may not have a Mini-Card installed.
1
Mini-Card
2
securing screw (2)
3
antenna cable connector (2)
Summary of Contents for Vostro A90
Page 10: ...Back to Contents Page ...
