Back to Contents Page
Replacing the System Board
Dell™ Vostro™ A100/A180 Service Manual
1.
Follow the procedures in
Before You Begin
.
2.
Remove the computer cover (see
Replacing the Computer Cover
).
3.
If applicable, remove the processor (see
Replacing the Processor (Dell™ Vostro™ A180 only)
).
4.
Remove the memory modules (see
Replacing Memory Module(s)
) and document which memory module is removed from each memory module connector
so that the memory modules can be installed in the same location after the board is replaced.
5.
Disconnect all cables from the system board.
6.
Remove the screws securing the system board as appropriate.
l
For Dell™ Vostro™ A100, remove the four screws securing the system board.
l
For Dell Vostro A180, remove the six screws securing the system board.
CAUTION:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTICE:
Do not perform the following steps unless you are familiar with hardware removal and replacement. Performing these steps incorrectly
could damage your system board. For technical service, see the Setup and Quick Reference Guide.
CAUTION:
The processor heat sink can get very hot during normal operation. Be sure that the heat sink has had sufficient time to cool before you
touch it.
NOTICE:
Carefully note the routing and location of each cable before you disconnect it, so that you are sure to re-route cables correctly. An
incorrectly routed or a disconnected cable could lead to computer problems.
1 system board 2 screws (4)
1 system board 2 screws (6)
Summary of Contents for Vostro A100
Page 5: ......
Page 18: ...Back to Contents Page ...
