Installing the Heatsink
1.
Place the heatsink into its original position on the system board.
2.
Tighten the screws to secure the heatsink to the system board.
3.
Install:
a) system fan
b) battery
c) base cover
4.
Follow the procedures in
After Working Inside Your Computer.
Removing the Memory
1.
Follow the procedures in
Before Working Inside Your Computer
.
2.
Remove:
a) base cover
b) battery
3.
Pry the securing clips away from the memory module until it pops up. Remove the memory module from its
connector on the system board.
Installing the Memory
1.
Insert the memory module into the memory socket.
2.
Press the memory module down until it clicks into place.
3.
Install:
a) battery
b) base cover
4.
Follow the procedures in
After Working Inside Your Computer
.
Removing the System Board
1.
Follow the procedures in
Before Working Inside Your Computer
.
2.
Remove:
a) base cover
b) battery
c) system fan
d) heatsink
e) hard drive
3.
Disconnect the following cables:
a) speaker
20
Summary of Contents for Vostro 5470
