Dell Networking SPR-RK3-MNT
Installation Guide
0511709-02 | April 2015
1
This document provides installation instructions for standard front-rack mounting the Dell W-7024/W-7205
controller in a standard two-post 19" Telco rack using the SPR-RK3-MNT accessory kit.
The W-7024/W-7205 controller is referred to as "device” in rest of the document.
Package Contents
Two rack mount brackets
Eight M4 x 8 mm Phillips Flat Head screws
Four M6 x 15 mm Phillips Pan Head screws
Four M6 cage nuts
Four M6 clip nuts
Installation Guide (this document, printed)
Standard Rack Mount Installation
This option allows mounting the device from the front in a standard two-post 19” Telco rack.
Required Tools and Equipment
Two rack-mount brackets
Eight M4 x 8 mm Phillips Flat Head screws
Four M6 x 15 mm Phillips Pan Head screws
Four M6 cage nuts (optional)
Four M6 clip nuts (optional)
Suitable screwdrivers (not included in this kit)
Installation Steps
To install the device in a two-point 19” (48.26 cm) rack system:
1. Place the mounting brackets over the mounting holes near the front on either sides of the device (see
).
NOTE: Some racks require screws that differ from those included with the device. Confirm that you have the correct screws
before installing the device.
CAUTION: Each device should have its own mounting equipment. Do not place other networking equipment directly on top of a
mounted device. Failure to do so can result in damage to the device.
NOTE: The figures in this document illustrate the installation procedure for the W-7205 controller. The same installation procedure
applies to the W-7024 controller.
